automatic boots surface stenters 1. the machine is suitable for various vamp the instep become warped degrees to finalize the design, for there is biggish area of super thick vamp can also operate freely. 2. plastic knife on pressure by 2-phase marching, safe in operation, vamp center accurate location. 3. the machine visual vamp area size adjustment according to schedule required the depth, adjust material characteristic required under pressure, blanking and speed, finalize the design time, finalize the design temperature, the knife top material pressure, the vamp can finalize the design become warped degrees more perfect. 4. the machine visual vamp become warped degree angle easy replacement daomu, the vamp can become warped degree and xuantou become warped degrees, reduce loss consistent. 5. by belt fine-tune the cylinder, can adjust on both sides of the board, excluding the distance of boots ruffled, broken etc. phenomenon, in order to achieve the **** effect. face finalize the boots 6. using dual bending type face high boots boots shaped-machine instep curvature whole out double become warped degrees to finalize the design better effect, make become warped degrees practically identical paper lattice. note: for ye - 2216a single looper automatic boots surface stenters; for ye - 2216b steel-fiber with automatic boots surface stenters mechanical sizes air source power output 1680x850x700mm 0.6 mpa 220v / 50hz 1500 double / 8